Comprima Plus

• „„Powerful - large-diameter rotor
• „„Quiet running - helical tine rows „„
• Sharp - superior cutting quality „„
• Flexible - 17 or 26 blades
• „„Robust - hard-wearing rotor

The XCut cutting system comprises the feed rotor and the blade cassette for superior crop feeds, quiet running and exceptional cutting quality. The components in the blade cassette are also made from heard-wearing materials to match the Hardox steel rotor cutter.

Should the feed chamber block up in difficult conditions, the operator simply lowers and raises the blade cassette hydraulically to remove the blockage. If the unit is specified with hydraulic blade group control, the blades will also be retracted automatically to clear the chamber and allow the crop to flow again.

Featuring three helical rows of tines and a massive 53 cm diameter, the powerful XCut rotor has the capacity to provide consistent crop flows and precision cuts while spreading the material across the full width of the feed chamber, which is essential for forming firm edges. The rotor is made from hard tempered material (Hardox steel) for extra longevity.

The cutting rotor is powered by oversize spur wheels which cope with the highest possible loads. They provide the rotor with the most dependable drive even in less than uniform swaths.

The double tines pull the crops consistently through the blades. The gap between the tines and the blades is extremely small so that not a single haulm will pass the blades without cutting. This force-cut is precise and requires little force.

To fit or remove the blades, simply lower the blade cassette. To unlock the blades, all springs on the single blade locking device are released in one operation. and remove the blades conveniently from above.

The blades are protected from damage by spring locks. break back when hitting an object and then resume their working position automatically after the object has passed, a system that results in dependable and high-quality cuts.

 

Depending on the required length of cut, the blade cassette of the XCut cutting system has a maximum of 17 or 26 blades. When 8, 9 or 17 blades are in working position, the nominal chop length is 128 mm or 64 mm whereas the use of 13 or 26 blades reduces the chop length to 84 mm or 42 mm.

The standard manual control is a long lever that takes little effort to operate. This way you can quickly adjust the number of blades to varying conditions and customer needs.

The hydraulic blade group control system is an option and the system is operated from the convenience of the cab, hence saving valuable time.